Step 7: Connect the PLCs to Corvina

Establish an online connection between Control FPWIN Pro7 and the PLCs.

Perform this task for each PLC type.

1. Start Control FPWIN Pro7.

2. Open your project.

3. Go to Online > Communication parameters... .

   Make the following settings:

   Connection type: Ethernet

   Configuration name: Enter a title for your Ethernet connection.

   IP address: Paste the virtual IP addresses copied from the Corvina Cloud App Lite. For the FP0H, use the virtual IP address of the endpoint FP0H. For the FP0R, use the virtual IP address of the gateway FP-I4C.

   Port number: 9094 (must match the port setting for COM1 RS232 of the FP‑I4C unit)

4. Select OK to save your settings.

5. Select Online > Online mode to establish the VPN connection to both PLCs.

   If the connection fails, refer to the troubleshooting section for advice.

6. Transfer the configuration to the PLC.