Supported PLCs

PLC series	Version	PLC types		Comment
PLC series	Version	16-bit	32-bit	Comment
FP-X0		●		2,5k L14,L30 8k L40,L60 16k L40,L60
FP-X	Ver.: 1.1 or higher	●		Relay types: 16k C14R and 32k C30R, C60R Transistor types: 16k C14T and 32k C30T/P, C60T/P, C38A, C40T
FP-XH		●		16k C14R 32k C30R, C40R, C60R 16k C14T/P 32k C30T/P, C40T/P, C60T/P 32k C38 AT 32k M4T16T 32k M8N16T (RTEX) 32k M8N30T (RTEX)
FP0H		●		C32T/P C32ET/P
FP-e		●		FP-e 2,7k
FPS	Ver.: 1.0 or higher	●
FP0	Ver.: 1.0 or higher	●		REAL functions only from Ver. 2.1 onwards
FP0R	Ver.: 1.0 or higher	●		Program exchange between FP0 and FP0R: You can run an FP0 program with an FP0R and vice versa if the PLC type is exactly the same, e.g. FP0 C10,C14,C16 and FP0R C10,C14,C16.
FP2	Ver.: 1.02 or higher	●		STRING functions only from Ver. 1.04 onwards MCU functions only from Ver.1.4 onwards Data transfer instructions (F159) including IsReceptionDone and IsTransmissionDone also only from Ver.1.4 onwards
FP3	Ver.: 4.4 or higher	●		only FP3 CPUs with suffix C
FP5	Ver.: 4.4 or higher	●
FP10/10S	Ver.: 1.0 or higher	●
FP10SH	Ver.: 2.0 or higher	●		STRING functions only from Ver. 3.02 onwards
FP2SH	Ver.: 1.03 or higher	●		MCU functions only from Ver.1.4 onwards Data transfer instructions (F159) including IsReceptionDone and IsTransmissionDone also only from Ver.1.4 onwards
FP7	Ver.: 1.33 or higher		●	EtherNet/IP function from Ver.4.00 or higher
ELC500			●

NOTE

If you are using an FP2 PLC V1.04 or lower, system register 9 (holding file registers (FL)) must be set to zero (0). If you do not, the PLC will prompt a system register error.
The FP3 10K CPUs are available in two variants and can be distinguished by their part number (with C at the end and without C at the end). The CPUs with part numbers ending on C are supported 100% by NAiS Control version 2.3 and higher. The CPUs with the part numbers AFP3210J/EMJ, AFP3211J/EMJ and AFP3212J/EMJ (without C at the end) are not supported 100%, and Control FPWIN Pro7 will not perform a syntax or compiler check of the instructions, operators, functions blocks, etc. available for CPUs with part numbers ending on C. This is why we recommend using only FP3 CPUs with part numbers ending on C.
CPUs with version numbers lower than those specified for Control FPWIN Pro7 can generally be programmed, too. However, the compiler does not check whether the instruction or function, etc. is really available for this version. Please refer to the relevant FP-series technical manuals.